Delta 31-695 User Manual

19 - English
END-SANDING WITH THE DISC
When sanding the ends of narrow workpieces, use the sanding disc and the accessory miter gauge (Fig. 48). Move the
work from the center to the left side of the sanding disc.
Always sand on the left (downward) side of the sanding disc. Sanding on the right (upward) side of
the sanding disc could cause the workpiece to fly up, which could be hazardous.
The edge of the table must be positioned a maximum of 1/16" away from the sanding disc to avoid
trapping the work or fingers between the table and the sanding disc.
END-SANDING WIDE WORKPIECES WITH THE BELT
When sanding the ends of wide workpieces, move the table assembly to the the sanding belt and use the sanding arm
in the vertical position (Fig. 49). See sections titled "CHANG ING POSITION OF SANDING ARM" and"USING TABLE
ASSEMBLY WITH SANDING BELT."
For more accurate work use the accessory miter gauge and move the work evenly across the sanding belt (Fig. 49).
Always sand on the left (downward) side of the sanding disc. Sanding on the right (upward) side of
the sanding disc could cause the workpiece to fly up, which could be hazardous.
Fig. 48
Fig. 49
TROUBLESHOOTING
For assistance with your machine, visit our website at www.deltamachinery.com for a list of service centers or call the
DELTA Machinery help line at 1-800-223-7278 (In Canada call 1-800-463-3582).

Delta 31-695 Specifications

General

Brand	Delta
Model	31-695
Category	Sander
Language	English