Delta E Series Software Instructions

Recipe Setting Software Instruction
8
2.3 Introduction to Pressing Mode
Pressing conditions include the target value and limit value corresponding to each mode. The maximum
limit value is part of the pressing process to ensure that no damage is done to the work piece due to
excessive pressing. The minimum limit value will be checked after reaching the target condition to
confirm whether this limit range has been reached. The following describes the pressing parameters for
each mode.
2.3.1 Motionless
No pressing parameters set. If this step is reached during the execution of the recipe, the pressing
action will be ended.

Delta E Series Specifications

General

Brand	Delta
Model	E Series
Category	Inverter
Language	English