Chapter 12 Description of Parameter SettingsME300
12.1-14-1
14 Protection Parameters (2)
You can set this parameter during operation.
Output Frequency at Malfunction 2
Output Frequency at Malfunction 3
Output Frequency at Malfunction 4
Output Frequency at Malfunction 5
Output Frequency at Malfunction 6
Default: Read only
Settings 0.00–599.00 Hz
When an error occurs, you can check the output frequency for the malfunction. If the error
happens again, this parameter overwrites the previous record.
DC Voltage at Malfunction 2
DC Voltage at Malfunction 3
DC Voltage at Malfunction 4
DC Voltage at Malfunction 5
DC Voltage at Malfunction 6
Default: Read only
Settings 0.0–6553.5 V
When an error occurs, you can check the DC voltage for the malfunction. If the error happens
again, this parameter overwrites the previous record.
Output Current at Malfunction 2
Output Current at Malfunction 3
Output Current at Malfunction 4
Output Current at Malfunction 5
Output Current at Malfunction 6
Default: Read only
Settings 0.00–655.35 Amps
When an error occurs, you can check the output current for the malfunction. If the error happens
again, this parameter overwrites the previous record.
IGBT Temperature at Malfunction 2
IGBT Temperature at Malfunction 3
IGBT Temperature at Malfunction 4
IGBT Temperature at Malfunction 5
IGBT Temperature at Malfunction 6
Default: Read only
Settings -3276.7–3276.7
o
C
When an error occurs, you can check the IGBT temperature for the malfunction. If the error
happens again, this parameter overwrites the previous record.
To Next Page
Loading...
Need help?
General