145
Registering preset codes
When preset codes are registered in the included remote control unit,
it can then be used to operate any devices you have, such as DVD
players or TVs made by different manufacturers.
n Buttons used for operating the devices
q DEVICE X
For switching power of each device on or off.
w uio p, ENTER, BACK
For menu operation of each device.
e MENU, INFO, OPTION, SETUP
For displaying the menu of each device.
r 8, 9, 1, 6, 7, 3, 2
t Number button (0 – 9, +10)
y CH/PAGE df
u TV X, TV INPUT
For operating a TV
This button is enabled in any mode.
For details on operation with the remote control unit, see pages
41, 44, 53, 56, 60, 63, 66, 68, 149, 150
NOTE
The preset code cannot be registered to TUNER, PHONO, iPod/USB,
NETWORK and INTERNET RADIO.
Registering preset codes
1
Press and hold down the input
source select buttons for the
appliance to control, and press
SETUP until the operation mode
indicator blinks.
NOTE
Note that the group numbers that can be
registered are predefined for each input
source select button.
2
Press the 5-digit code for the
appliance using 0 – 9 (code table
at the end of this manual).
When the procedure is successful, the
operation mode indicator blinks twice.
NOTE
If the operation mode indicator did not blink
twice, then repeat steps 1 and 2 and try
entering the same code again.
Operating external devices with the remote control
By registering preset codes for external devices to the provided remote control, you can operate your TV and playback devices (such as Blu-ray Disc player and DVD player) with the remote control.
Some manufacturers use more than one type of remote control code.
Preset codes to change the number and verify correct operation.
NOTE
Depending on the model and year of manufacture of your device,
some buttons may not operate.
To Next Page
Loading...
Need help?
General
Weight and Dimensions
