EasyManuals Logo
Home>Denon>Stereo Receiver>AVR-X4400H

Denon AVR-X4400H Manual

Denon AVR-X4400H
198 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #71 background imageLoading...
Page #71 background image
o
DHCP
Selects how to connect to the network.
On
(Default):
Configure the network settings
automatically from your router.
Off: Configure the network settings manually.
o
IP Address
Set the IP address within the ranges shown below.
0
The Network Audio function cannot be used if other IP addresses
are set.
CLASS A: 10.0.0.1 - 10.255.255.254
CLASS B: 172.16.0.1 - 172.31.255.254
CLASS C: 192.168.0.1 - 192.168.255.254
o
Subnet Mask
When connecting an xDSL modem or connector adapter directly to
this unit, input the subnet mask indicated in the documentation
supplied by your provider. Normally input “255.255.255.0”.
o
Default Gateway
When connected to a gateway (router), input its IP address.
o
DNS
Enter the DNS address indicated in the documentation supplied by
your provider.
0
If you cannot connect to the Internet, recheck the connections and settings.
(v p. 85)
0
If you do not understand about Internet connection, contact your ISP (Internet
Service Provider) or the store from which you purchased your computer.
Contents Connections Playback Settings Tips Appendix
239
Front panel Display Rear panel Remote Index

Table of Contents

Other manuals for Denon AVR-X4400H

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Denon AVR-X4400H and is the answer not in the manual?

Denon AVR-X4400H Specifications

General IconGeneral
Display-
ECO modeYes
HDCP version2.2
Apple dockingNo
Product colorBlack
Audio decodersDTS:X, Dolby Atmos
Audio formats supportedALAC, DSD, FLAC, WAV
AM band range522 - 1611 kHz
FM band range87.5 - 108 MHz
Supported radio bandsAM, FM
Supported graphics resolutions4096 x 2160
RS-232 ports1
Connectivity technologyWireless
HDMI in8
Composite video in4
Component video (YPbPr/YCbCr) in2
Receiver typeSurround
Frequency range10 - 100000 Hz
Pre-out channels11.2
Input sensitivity200 mV
Audio output channels9.2 channels
Signal-to-Noise Ratio (SNR)100 dB
Power output per channel (1KHz@6 Ohm)200 W
Power output per channel (20-20KHz@8 Ohm)125 W
AC input voltage230 V
AC input frequency50 Hz
Power consumption (standby)0.5 W
Power consumption (typical)710 W
Number of HDMI outputs3
Weight and Dimensions IconWeight and Dimensions
Depth389 mm
Width434 mm
Height167 mm
Weight13500 g

Related product manuals