TECHNICAL SPECIFICATIONS FOR AVR-S510BT
n
Audio Section
• Power amplier
Rated output :
Front :
70 W + 70 W (8 Ω/ohms, 20 Hz – 20 kHz with 0.08 % T.H.D.)
90 W + 90 W (6 Ω/ohms, 1 kHz with 0.7 % T.H.D.)
Center :
70 W (8 Ω/ohms, 20 Hz – 20 kHz with 0.08 % T.H.D.)
90 W (6 Ω/ohms, 1 kHz with 0.7 % T.H.D.)
Surround :
70 W + 70 W (8 Ω/ohms, 20 Hz – 20 kHz with 0.08 % T.H.D.)
90 W + 90 W (6 Ω/ohms, 1 kHz with 0.7 % T.H.D.)
Output connectors : 6 – 16 Ω/ohms
• Analog
Input sensitivity/Input impedance : 200 mV/47 kΩ
Frequency response: 10 Hz – 100 kHz — +1, –3 dB (Direct mode)
S/N : 98 dB (IHF–A weighted, Direct mode)
n
Tuner section
FM (Note: μV at 75 Ω, 0 dBf = 1 x 10
–15
W)
Reception frequency range : FM 87.5 MHz – 107.9 MHz
AM 520 kHz – 1710 kHz
Effective sensitivity : FM 1.2 μV (12.8 dBf)
AM 18 μV
50 dB sensitivity : FM MONO 2.8 μV (20.2 dBf)
S/N ratio : FM MONO 70 dB
(IHF–A weighted, Direct mode)
STEREO 67 dB
(IHF–A weighted, Direct mode)
Distortion : FM MONO 0.7 % (1 kHz)
STEREO 1.0 % (1 kHz)
n
Bluetooth Section
Communications system : Bluetooth Version 2.1 + EDR
(Enhanced Data Rate)
Transmission power : Maximum 2.5 mW (Class 2)
Maximum communication range : Approx. 32.8 ft/10m in line of sight
Frequency band : 2.4 GHz band
Modulation scheme : FHSS (Frequency-Hopping Spread
Spectrum)
Supported proles : A2DP
(Advanced Audio Distribution
Prole)1.2
AVRCP
(Audio Video Remote Control
Prole)1.5
Corresponding codec : SBC, AAC
Transmission range (A2DP) : 20 Hz - 20,000 Hz
n
General
Power supply : AC 120 V, 60 Hz
Power consumption : 310W
Power consumption in standby mode: 0.1 W
Power consumption when Bluetooth standby is used: 1W
For purposes of improvement, specications and design are subject to
change without notice.
9