ENGLISH
11
o
Time mode indicators
• When the TIME button is pressed, the time display switches
as follows:
When “ELAPSED” is lit:
The track’s elapsed time is displayed.
When “REMAIN” is lit:
The track’s remaining time is displayed.
When “TOTAL” and “ELAPSED” are lit:
The disc’s total elapsed time is displayed.
When “TOTAL” and “REMAIN” are lit:
The disc’s total remaining time is displayed.
!0
Next track display
• This displays the number of the next tack to be played.
!1
Pitch display
• This indicates the playback speed (pitch).
(–16.0 to +16.0)
!2
PLAT-H indicator
• This lights when in the PLAT-H mode.
!3
Loop mode indicators
• “ ” lights when in the loop mode.
• “ ” lights when point B is set for point A-1.
• “ ” lights when point B is set for point A-2.
• “ ” lights when in the seamless loop pause mode.
!4
Digital out indicator
• This lights when the digital output is turned on with the
presettings.
!5
Shockproof data indicator
• This lights when the shockproof memory is full.
!6
Button lock indicator
• Some of the buttons do not function when this indicator is lit.
!7
Character display
• Operation messages are displayed here.
!8
Bar indicator
• This provides a visual indication of where the pickup is within
the currently playing track.
!9
EOM indicator
• This flashes when the EOM time set with the presettings is
reached.
@0
ASP mode indicators
• “ ” lights when the ASP is set to the sampler playing
mode.
• “ ” lights when the ASP is set to the digital scratch
mode.
• “ ” lights when the ASP is set to the effector
mode.
@1
Effector operating mode indicators
• “ ” lights when in the filter mode.
• “ ” lights when in the reverb mode.
• “ ” lights when in the flanger mode.
@2
Sampler playing mode indicators
• “LOOP” lights when in the sampler loop playing mode.
• “RVS” lights when in the sampler reverse playing mode.
4
COMPACT DISCS
1. Precautions on handling compact discs
• Do not allow fingerprints, oil or dust to get on the surface of the
disc.
If the disc is dirty, wipe it off with a soft dry cloth.
• Do not use benzene, thinner, water, record spray, electrostatic-
proof chemicals, or silicone-treated cloths to clean discs.
• Always handle discs carefully to prevent damaging the surface;
in particular when removing a disc from its case or returning it.
• Do not bend the disc.
• Do not apply heat.
• Do not enlarge the hole in the center of the disc.
• Do not write on the label (printed side) with a hard-tipped
implement such as a pencil or ball point pen.
• Condensation will form if a disc is brought into a warm area
from a colder one, such as outdoors in winter. Do not attempt
to dry the disc with a hair dryer, etc.
2. Precautions on storage
• After playing a disc, always unload it from the player.
• Always store the disc in the jewel case to protect from dirt or
damage.
• Do not place discs in the following areas:
1) Areas exposed to direct sunlight for a considerable time.
2) Areas subject to accumulation of dust or high humidity.
3) Areas affected by heat from indoor heaters, etc.
To Next Page
Loading...
Need help?
General
