Changing the Speaker’s Equalizer
1
Select “EQ”.
2
Adjust the Treble or Bass up or down.
NOTE
Select the Reset button to restore the default settings.
Changing the Speaker’s Orientation
(HEOS 3 Only)
The HEOS 3 can be placed both vertically and horizontally.
Each orientation has it’s own sound tuning and should be set accordingly
for optimal sound quality.
1
Select “Orientation”.
2
Select “Vertical” if you placed your HEOS 3 vertically or
select “Horizontal” if you placed your HEOS 3
horizontally.
3
Select the Back button and your settings are
automatically saved.
Adjusting the Audio Quality
Selects the transcoding option for rebroadcasting audio from one HEOS
device to another HEOS device (or group of devices) across the network.
When set to “Normal”, high bit rate audio sources originating from the first
device (such as AUX input, WAV, FLAC and PCM) will be transcoded to
ensure the highest level of reliability for the audio stream.
1
Select “Quality”.
2
Select Normal (default) or High.
0
If you have selected High and you experience audio dropouts when streaming
sources from one device to other devices, please select Normal (default).
0
This setting does not affect the AUX input when played on the connected device
by itself (there are no other devices grouped to it), in which case the original
source quality and bit rate are maintained and there is no inherent delay.
Adjusting the Status Light Brightness
1
Select “Status Light”.
2
Adjust the brightness up or down or set the slider to
the OFF position to completely disable the status light.
Contents Setup Use Troubleshooting Status LED Appendix
38
To Next Page
Loading...
Need help?
General
Weight and Dimensions
