Denon Heos Drive User Manual

Connecting Speakers (4 Stereo Zones)
o
Connecting Speakers
Carefully check the left (L) and right (R) channels and + (red) and –
(black) polarities on the speakers being connected to this unit, and be
sure to connect the channels and polarities correctly.
1
Peel off about 3/8 inch (10 mm) of sheathing from the
tip of the speaker cable, then either twist the core wire
tightly or terminate it.
.
2
Turn the speaker terminal counterclockwise to loosen
it.
.
3
Insert the speaker cable’s core wire to the hilt into the
speaker terminal.
.
4
Turn the speaker terminal clockwise to tighten it.
.
NOTE
0
Turn off the power switch of rear panel before connecting the speakers. Also, turn
off any connected powered subwoofers.
0
Connect so that the speaker cable core wires do not protrude from the speaker
terminal. The protection circuit may be activated if the core wires touch the rear
panel or if the + and – sides touch each other.
0
Never touch the speaker terminals while the power cord is connected and power
switch of rear panel is turned on. Doing so could result in electric shock.
0
Use speakers with an impedance of 4 – 16 Ω/ohms. The protection circuit may be
activated if speakers with an impedance other than specified are used.
.
(R)
wq
wq
(L)
Contents
Setup Use Troubleshooting Status LED Appendix
14

Denon Heos Drive Specifications

General

Audio decoders	Dolby Digital, Dolby Digital Plus
Amplifier class	D
Audio output channels	7.1 channels
Peak power per channel	60 W
Signal-to-Noise Ratio (SNR)	- dB
Total Harmonic Distortion (THD)	0.05 %
Pre out port	Yes
USB 2.0 ports quantity	4
Speakers connectivity type	-
Purpose	Home
Product color	Black
Cables included	AC, LAN (RJ-45)
Connectivity technology	Wired
AC input voltage	100-240 V
AC input frequency	50 - 60 Hz
Operating temperature (T-T)	5 - 35 °C

Weight and Dimensions

Depth	402 mm
Width	430 mm
Height	88 mm
Weight	7200 g