Denon Heos Drive User Manual

Resetting Your HEOS Device
Solution Refer to Page
Resetting your HEOS device will clear out EQ, and name but retain it’s current software. You will have to use Settings->Add
Device to reconnect the device to your home network before it can be used. To reset your HEOS Drive, press the Reset button on
the back and hold it in until the Zone LED begins to flash amber.
–
Restoring the HEOS Device to Factory Defaults
Solution Refer to Page
Restoring the HEOS device to its factory defaults will clear all of the settings and restore the original software which was installed
at the factory.
Caution
All settings will be erased and the software will likely be downgraded!
To restore your HEOS Drive to the factory defaults, turn off the power switch of rear panel. Press the Reset button on the back,
turn on the power switch of rear panel, and hold it in until the Zone LED begins to flash amber.
–
* For further information, please visit HEOSbyDenon.com
Contents
Setup Use Troubleshooting Status LED Appendix
49

Denon Heos Drive Specifications

General

Audio decoders	Dolby Digital, Dolby Digital Plus
Amplifier class	D
Audio output channels	7.1 channels
Peak power per channel	60 W
Signal-to-Noise Ratio (SNR)	- dB
Total Harmonic Distortion (THD)	0.05 %
Pre out port	Yes
USB 2.0 ports quantity	4
Speakers connectivity type	-
Purpose	Home
Product color	Black
Cables included	AC, LAN (RJ-45)
Connectivity technology	Wired
AC input voltage	100-240 V
AC input frequency	50 - 60 Hz
Operating temperature (T-T)	5 - 35 °C

Weight and Dimensions

Depth	402 mm
Width	430 mm
Height	88 mm
Weight	7200 g