English
6
• Avoid prolonged
contact with dust
from power
sanding, sawing,
grinding, drilling,
and other
construction
activities. Wear
protective
clothing and
wash exposed areas
with soap and water.
Allowing dust to get
into your mouth, eyes,
or lay on the skin may
promote absorption of
harmful chemicals.
WARNING: Use of
this tool can
generate and/ or
disperse dust, which
may cause serious
and permanent
respiratory or other
injury. Always use
NIOSH/OSHA
approved
respiratory
protection
appropriate for the
dust exposure.
Direct particles
away from face and
body.
WARNING: Always
wear proper personal
hearing protection
that conforms to ANSI
S12.6 (S3.19) during
use. Under some
conditions and duration
of use, noise from this
product may contribute
to
hearing loss.
CAUTION: When not
in use, place tool on
its side on a stable
surface where it will
not cause a tripping or
falling hazard. Some
tools with large battery
packs will stand upright
on the battery pack but may be easily knocked over.
• Air vents often cover moving parts and should be avoided. Loose clothes,
jewelry or long hair can be caught in moving parts.
The label on your tool may include the following symbols. The symbols and their
definitions are as follows:
V ......................... volts or AC/DC ....alternating or
Hz .......................hertzdirect current
min .....................minutes ...................... Class II
or DC ......direct current
Construction
...................... Class I Construction
(double insulated)
(grounded) no .......................no load speed …/min
..............per minute n .........................rated speed
BPM ....................beats per minute ......................earthing terminal
IPM .....................impacts per minute
.....................safety alert symbol RPM .................... revolutions per
.....................visible radiation
minute ..................... wear respiratory
surface feet per
protection
minute ..................... sfpm ...................
wear eye
SPM ....................strokes per minute
protection
A .........................amperes ..................... wear hearing
W ........................watts
protection
or AC ...........alternating current
..................... read all
documentation
BATTERIES AND CHARGERS
The battery pack is not fully charged out of the carton. Before using the battery
pack and charger, read the safety instructions below and then follow charging
procedures outlined. When ordering replacement battery packs, be sure to
include the catalog number and voltage.
Your tool uses a DeWALT charger. Be sure to read all safety instructions before
using your charger. Consult the chart at the end of this manual for compatibility
of chargers and battery packs.
READ ALL INSTRUCTIONS
Important Safety Instructions for All Battery Packs
WARNING: Read all safety warnings and all instructions for the battery pack,
charger and power tool. Failure to follow the warnings and instructions may
result in electric shock, fire and/ or serious injury.
• Do not charge or use the battery pack in explosive atmospheres, such as in
the presence of flammable liquids, gases or dust. Inserting or removing the
battery pack from the charger may ignite the dust or fumes.
• NEVER force the battery pack into the charger. DO NOT modify the battery
pack in any way to fit into a non-compatible charger as battery pack may
To Next Page
Loading...
Need help?
General
