Digi Connect and ConnectPort TS Family command-line
interface
Management through the command line
interface
Digi Connect Family and ConnectPort TS Family
117
n set network
n set permissions
n set pmodem
n set pppoutbound
n set profiles
n set realport
n set rtstoggle
n set serial
n set service
n set snmp
n set system
n set tcpserial
n set udpserial
n set user
n set wlan
close
Use the close command to close active sessions that were opened by connect, rlogin, and telnet
commands.
connect
Use the connect command to establish a connection with a serial port.
display
Use the display commands to display real-time information about a device, such as:
n General product information, including the product name, MAC address, boot, post, and
firmware versions, memory usage, utilization, and uptime, or the amount of time since the
device was booted (display device).
n Active interfaces on the system. These include the web interface, command line interface,
Point-to-Point Protocol (PPP), and Ethernet interface, and their status, such as Closed or
Connected (display netdevice).
n GPIO signals (display gpio).
n Logged serial data (display logging/).
n Memory usage information (display memory).
n Serial modem signals (display serial).
n General status of the sockets resource (display sockets).
n Active TCP sessions and active TCP listeners (display tcp).
To Next Page
Loading...
Need help?
General