26
The JamMan
®
Stereo’s Auto Record feature lets the JamMan automatically
begin recording when you begin playing or when audio is detected at the
JamMan Stereo’s inputs. When enabled, Auto Record works globally on all
empty loop memories; you cannot use Auto Record with an existing loop.
When the REC/PLAY/OVERDUB footswitch is pressed, the JamMan Stereo is
armed for recording but won’t start recording until you start playing (the
RECORD status and REC/PLAY/OVERDUB footswitch LEDs flash red to show that
the JamMan is armed). The JamMan monitors the input level and starts the
recording when it detects an audio signal.
If you’ve tapped in a tempo while Auto Record is enabled, the rhythm guide
track will begin playing. Pressing the REC/PLAY/OVERDUB footswitch will arm
the JamMan Stereo for recording. As soon as signal is detected, recording
will begin immediately.
Changing to an empty loop memory while AUTO REC is enabled will preserve
the AUTO REC state (the AUTO REC button will turn off when a memory that
has a loop already stored in it is selected).
To turn off Auto Record, press the AUTO REC button until it turns off.
Auto Record Mode
To Next Page
Loading...
Need help?
General
