38
Anytime a change is made to a loop memory location (Rhythm Type, Tempo,
Time Signature, Record, Overdubs etc.) the STORE button will immediately
light. This indicates that the changes will be lost unless a store procedure
is performed before selecting a new loop memory location, turning off the
power.
Store Changes to a Loop
Stop any recording activity using the 1. TEMPO/STOP footswitch.
Press the 2. STORE button. The STORE button and the DISPLAY will begin
to flash (the DISPLAY shows the current loop memory location).
(Optional) Turn the 3. SELECT knob to select an empty loop memory
location to store the loop with its changes (the LOOP or SINGLE LEDs
are off), or press EXIT to abort.
Press the 4. STORE button again. The changes are now saved and the
STORE button turns off.
Copy a Loop to a Different Memory Location
Stop any playback or record activity using the 1. TEMPO/STOP footswitch.
Turn the 2. SELECT knob to select a memory location that contains a
loop (either the LOOP or SINGLE LED is lit).
Press the 3. STORE button. The DISPLAY and the STORE button will begin
to flash.
Turn the 4. SELECT knob until an empty memory location is selected
(the LOOP and SINGLE LEDs are off), or press EXIT to abort.
Press the 5. STORE button again. The loop is now copied to the new
memory location.
Note: The Clear and Overdub Undo/Redo functions cannot be performed
to the loop after a Store/Copy procedure.
Storing/Copying Phrases
To Next Page
Loading...
Need help?
General
