DigiTech JAMMAN - MANUAL 2 User Manual

55
Formatting SD Cards
A memory card that is inserted into the JamMan
®
Stereo for the first time
should be formatted using the JamMan Stereo’s format procedure. To format
an SD/SDHC Card in the JamMan Stereo, follow these steps:
Enable the 1. SHIFT button and then press and hold the DELETE button
for four seconds. The DISPLAY will show FO (Format) and this button
will begin flashing.
Press the 2. DELETE button again. The DISPLAY will read F? (Format ?)
and the DELETE button will continue to flash. To abort this procedure,
press the EXIT button at any time.
To initiate the card formatting procedure, press and hold the 3. DELETE
button again for two seconds. The DISPLAY will show Bu indicating
the card is being formatted.
Unformatted Cards
If a memory card is inserted into the JamMan Stereo that does not have a
valid format, the JamMan Stereo will not recognize it and the DISPLAY will
read nF. The card must be formatted before the JamMan Stereo can use it.
To format the card, follow these steps:
While the 1. DISPLAY reads nF, the STORE button will begin flashing
prompting for a format confirmation.
Press the flashing 2. STORE button. The DISPLAY will read F? and the
STORE button will continue to flash. You can press the EXIT button to
abort the procedure.
To initiate the card formatting procedure, press and hold the 3. STORE
button for two seconds. The DISPLAY will show Bu indicating the
card is being formatted. Once completed, the DISPLAY will read 1 and
the card is now ready for recording.
Using Optional SD/SDHC Memory Cards

DigiTech JAMMAN - MANUAL 2 Specifications

General

Brand	DigiTech
Model	JAMMAN - MANUAL 2
Category	Music Pedal
Language	English