Amount -The Parameter 2 knob adjusts the Amount of Compression (ratio and sustain) and
ranges from 1 (slight compression) through 20 (maximum sustain).
Gain -The Parameter 3 knob adjusts the Output Gain from the Compressor.Ranges from 0
to 6.
Amp Modeling
Amp Modeling is a technology which applies the tone of several popular modern and vintage
amps.Amp Modeling also includes an acoustic guitar simulation.
Amp Gain - The Parameter 1 knob adjusts the Gain (distortion) for the selected Amp Model
(not available for Acoustic).The Gain parameter ranges from 0 to 99.
Amp Level - The Parameter 2 knob adjusts the Level (volume) of the selected Amp Model.
The Level parameter ranges from 0 to 99.
Amp Type - The Parameter 3 knob selects the 12 types of Amp Models.
Marshall® is a registered trademark of Marshall Amplification Plc. Vox® is a registered trademark of Korg UK. Fender,
Matchless,and Mesa Boogie,are trademarks of their respective companies and are in no way associated with DigiTech.
EQ
Equalization is an extremely useful tool used to further shape the tonal response of your
guitar signal.The EQ in the RP100 is similar to the tone knobs on an amplifier.All three EQ
parameters range from -12dB to +12 dB.
bf - Based on a ‘65 Fender Twin Reverb
bo - Based on a Matchless DC30
re - Based on a Mesa Dual Rectifier
hr - Based on a Mesa Boogie Mark II C
td - Based on a ‘57 Fender Tweed Deluxe
C1 - Based on a Vox AC30 top boost
C2 - A clean tube combo setting
St - Based on a Marshall JCM900
Cr - A nice crunchy combo
Hg - Based on the Johnson JM150 High Gain
Fu - A vintage fuzz distortion
AC - A flat top acoustic guitar
17
To Next Page
Loading...
Need help?
General
