1. Footswitches -These 2 Footswitches are used to select Presets,access the Tuner, or bypass
the RP100.The Footswitch on the right will increase, and the Footswitch on
the left will decrease the selected Preset.Pressing both Footswitches together
will bypass the currently selected Preset.Pressing and holding both
Footswitches will access the Tuner.
2. Parameter Knobs -The Parameter knobs perform various functions depending on which
mode is currently active in the RP100.In performance mode, these knobs
control the Gain,Amp Type, and Master Level. In Edit mode, these knobs
adjust the Parameter values listed directly above each knob for the select-
ed effect.In Rhythm Trainer,these knobs control the Pattern,Tempo,and
Level.In Tuner mode, these knobs are used to select the desired tuning
reference.
3. Select Button -This button is used to enter the Edit mode,and to select individual effect to
be edited.Successive presses of this button will advance through all available
Effects.
4. Rhythm -The Rhythm button is used to turn on and off the Rhythm Trainer drum loop.When
the Rhythm feature is active, the Rhythm LED lights and the selected drum pattern
plays continuously.
5. Matrix -The matrix provides information regarding the current Preset,and Parameter edit
functions.In performance mode,the 9 LEDs running down the left side of the Matrix
will provide a visual indication of which effects are in use for the currently selected
Preset.In Edit mode, the LEDs indicate the Effect currently selected for editing.In
Tuner mode,the LEDs indicate whether the note played is sharp, flat,or in tune.
3
To Next Page
Loading...
Need help?
General
