To Next Page

To Previous Page

• Press Function key 2. The display reads:

• Press Function key 1. The display reads:

• Press the <RIGHT> Cursor key. The display reads:

• To change the CC pedal transmit channel numbers, press the

appropriate Function key to select whether you want to change

the setting for the internal or external pedal and use the

<UP / DOWN> Cursor keys or the Data wheel to change the

Channel as desired.

• Press the <RIGHT> Cursor key again. The display reads:

• The footswitches which have been assigned with toggle CC

functions also have a selectable MIDI channel. This allows the

CC pedal to control a different external MIDI device than the

toggle CC footswitches.

In order for the external units to respond to CC messages you’ve set

up to transmit out the Valve FX MIDI Out port, it is necessary to set

them up to respond to the same MIDI Channel and CC numbers that

you’ve just set.

PEDAL CALIBRATION The next step is calibrating the CC pedal(s) so that the Valve FX

knows what ranges of control the pedal(s) can generate. Calibrating

CC pedals allows the Valve FX to handle CC messages with the great-

est efficiency and smoothness. Calibration procedures are the same

for both the Control One’s internal (built-in) continuous control pedal

and the external pedal that connects to the Valve FX. Although cali-

bration is not required everytime the Valve FX is powered up, it is a

good idea to calibrate regularly to insure pedal accuracy. The proce-

dure is as follows:

¡Toggle Transmit

≤ Channel 1

¡Int Xmit:Ch 1

≤™Ext Xmit:Off ≥

¡IntPedal:CC 4

™ExtPedal:CC 16≥

¡Assign Pedal CC

™Calibrate Pedal

Section 5 - The Utility Menu

Valve FX Owner’s Manual

DigiTech VALVEFX User Manual

Questions and Answers: