47
• Press the <RIGHT> Cursor key once. The display reads:
This screen tells you that when the Valve FX sends or receives
MIDI Program Change number 1, the selected device will be
sent Program Change number 1 on its designated MIDI channel.
• Press Function key 2 once. The cursor appears under
™Prg:1
.
• Using the <UP>/<DOWN> Cursor key, select the Valve FX
Program number (1-256) that will send the mapped Program
Change to the external device.
• Press Function key 3 once. The cursor now appears under
£As:#
. This Parameter determines the Program Change num-
ber that the external device will receive when the appropriate
Program Change number is received on the Valve FX. If this
parameter is set to
Disabl
, the Valve FX will send nothing to
that particular external device. Select the Program Change
number that will be sent (
1-128
,
Disabl
) using the
<UP>/<DOWN> Cursor keys.
You may map as many of the Program Changes as you like. These
are stored in memory automatically, and are always active until you
change them or until the factory presets are restored.
PRG RCV MAP The
Prg Rcv Map
function allows you to map incoming Program
Changes that are within MIDI range to any Program out of MIDI
Program Change number range on the Valve FX. For example, sup-
pose you want to access Program #146 using a MIDI Program
Change. Since MIDI only supports Program Change numbers 1 -
128, Program Change number 146 would normally be impossible for
the Valve FX to recognize. With the Valve FX’s flexible MIDI input
mapping, however, you can assign a Program Change number that
MIDI will recognize to be received as Program #146 on the Valve FX.
To illustrate, let’s assign MIDI Program Change number 26 to change
the Valve FX to Program #146.
• After entering the main MIDI setup menu, scroll <RIGHT> until
the display reads:
¡Prg Send Map
≤™Prg Rcv Map ≥
¡Device # Send
™Prg:1 £As:1
Section 5 - The Utility Menu
Valve FX Owner’s Manual
To Next Page
Loading...
Need help?
General
