- 32 -
Fig. 18
Fig. 16
Fig. 17
Fig. 15
IMPORTANT
Double check all mains connections are secure and excess cable is restrained and not in contact with any of the heater
casing.
ON NO ACCOUNT SHOULD ANY SURPLUS CABLE BE PUSHED INSIDE OR BEHIND THE HEATER.
Once installed DO NOT attempt to reposition the heater without fi rst unloading the energy cells.
Reassembly
To replace the bottom grille and front panel, reverse steps Figs. 4, 5 & 6 (page 24) of these instructions under the
section headed Preparation.
Ensure all fi xings are secure.
Fi
. 1
i
. 1
Fi
. 18
Fi
. 1
15. The third row of energy cells is positioned in a manner
similar to the fi rst row. Again be careful not to damage
or dislodge the element. (Fig. 15)
16. Fit the fourth row of energy cells above the third row in
the upside position. Again, the fi rst energy cell should
be positioned fi rmly against the right-hand insulation,
and the second energy cell should be positioned fi rmly
against the left-hand insulation. (Fig. 16). Repeat for
the fi fth and sixth rows of energy cells built around the
third element to complete the core build.
17. Remember the top row of energy cells must be fi tted
upside down. (Fig. 17)
Check that all the energy cells are secure and evenly
located.
18. Close the core by refi tting the inner front panel
complete with insulation, starting at position and
working clockwise. (Fig. 18)
Ensure the bottom tabs are located inside the chassis and
that the screws are tightly secured down each edge.
Ensure the screws retaining the heater to the wall are fully
tightened, once the energy retention cells are fully loaded.
(Fig. 7, page 25)
To Next Page
Loading...
Need help?
General
