iii
Important Safety Instructions, continued
20 Never insert objects of any kind into the receiver through openings, as the objects
may touch dangerous voltage points or short out parts. This could cause re or
electrical shock.
21 Do not locate the antenna near overhead light or power circuits, or where it can fall
into such power lines or circuits. When installing the antenna, take extreme care to
avoid touching such power lines or circuits, as contact with them can be fatal.
22 Do not attempt to service the receiver yourself, as opening or removing covers
may expose you to dangerous voltage and will void the Limited Warranty. Refer all
servicing to authorized service personnel.
23 Unplug the receiver from the AC power outlet before cleaning.
24 Do not place the receiver in an enclosure such as a cabinet without proper
ventilation.
25 Do not install the receiver in any area where the temperature can be less than 40°F
or more than 113°F. If the receiver is cold to the touch, do not plug it in immediately.
Let it sit unplugged at room temperature for at least 45 minutes before plugging it in.
26 Use an outlet that contains surge suppression or ground fault protection. During an
electrical storm or when the receiver is left unattended and unused for long periods
of time, unplug the power cord from the wall outlet, disconnect the lines between the
receiver and the antenna, and disconnect the telephone line. These actions provide
additional protection against damage caused by lightning or power line surges.
27 Tighten all of the coaxial cable connections only by hand. If you use a wrench, you
may overtighten the connections and damage your equipment.
Proper Care of Your Equipment
• Always handle the receiver carefully. Excessive shock and vibration can damage it.
• If the equipment is turned on and needs to be moved, unplug the equipment and let
it sit for at least 30 seconds before moving it.
• The use of accessories or attachments not recommended by the receiver
manufacturer and voids the Limited Warranty.
• Do not stack the receiver on top of or below other electronic devices as this can
cause heat build-up and vibration.
• On some TVs, the presence of xed images for extended periods of time may
cause them to be permanently imprinted on the screen. Consult your TV user
guide for information on whether this a problem for your TV, what operating/viewing
restrictions apply to avoid this problem, and associated TV warranty coverage.
To Next Page
Loading...
Need help?
General
