DJI FPV
Remote Controller 3 User Manual
18
©
2024DJI All Rights Reserved
Optimal Transmission Zone
The signal between the goggles and the remote controller is most reliable when the remote
controller is positioned in relation to the goggles as shown below.
Optimal Transmission Zone
• In order to avoid interference, DO NOT use other wireless devices on the same
frequency as the remote controller.
Remote Controller Alert
The remote controller will sound an alert during RTH, and the alert be cancelled by pressing the
pause/RTH button. The remote controller sounds an alert when the battery level of the remote
controller is low (6% to 10%). A low battery level alert can be cancelled by pressing the power
button. The critical low battery level alert, which is triggered when the battery level is less than
5%, cannot be cancelled.
Calibrating the Remote Controller
The remote controller supports joystick calibration. Calibrate the control sticks when prompted
to do so:
1. Press the 5D button on the goggles and open the goggles menu.
2. Select Settings > Control > Remote Controller > RC Calibration.
3. Follow the instructions to calibrate the control sticks.
• DO NOT calibrate the device in locations with strong magnetic interference, such
as near magnets, parking lots, or construction sites with underground reinforced
concrete structures.
• DO NOT carry ferromagnetic materials such as mobile phones during calibration.
To Next Page
Loading...
Need help?
General
