Dometic Brisk II User Manual

19
EN
Value Air Distribution Box (ADB), Mechanical Installation
w
e
q
r
23 Passing the Wire Through the Filter Notch
q
Filter
e
ADB Second Slot
w
Filter Notch
r
115 VAC Power Supply Wire
and 6-pin Unit Electrical Cord
6. Slide out the filter to expose the filter notch.
7. Pass all of the available 115 VAC power supply wire
and 6-pin unit electrical cord through the filter notch
and through the second slot of the ADB.
7.2 Securing the Unit
NOTICE: Overtightening could damage the
rooop component’s base pan or ceiling template. Not
enough torque will cause an inadequate roof seal, and
could cause a leak.
I
All models in this manual use a four bolt pattern to
secure the ADB kit.
This section describes how to secure the
rooop component to the roof.
1. For units that fit within the 14.0 x 14.0 in.
(366 x 366mm) ceiling opening, press the entire unit
up toward the basepan and into the ceiling opening.
2. Use the following figures to determine the proper
mounting pattern and bolt location.
A
B
C
D
24 Mounting Bolt Pattern - All Models
w
w
w
w
q
25 Mounting Bolt Location - All Models
q
Ceiling Template
w
Mounting Bolt
3. Start each mounting bolt by hand, through the
ceiling template and up into the rooop component
base pan.
4. Tighten the mounting bolts to the correct torque
specifications.
– For the FreshJet, tighten all four mounting bolts
evenly at 22.2 in. lbs (2.5 N·m).
– For all other models, tighten all four mounting
bolts evenly within 40 to 50 in. lbs (4.7 to
5.6N·m).

Dometic Brisk II Specifications

General

Brand	Dometic
Model	Brisk II
Category	Air Conditioner
Language	English