20
EN
Installation Value Air Distribution Box (ADB), Mechanical
7.3 Wiring the Unit to the Power
Supply
o
r
i
w
q
a
e
y
t
u
26 Completing the Wiring
q
Junction Box Cover
Screws
y
Cable Connector
for 6-pin Unit Electrical
Cord (from the AC)
w
Junction Box Cover
u
Cable Connector
for 6-pin Unit Electrical
Cord (from the ADB)
e
Junction Box
i
Live Black and Neutral
White Wires (from the
ADB)
r
6-pin Unit Electrical
Cord (from the AC)
o
115 VAC Power Supply
Wire (from the roof
opening)
t
Junction Box Notch
a
Strain Relief
This section describes how to wire the power supply to
the rooop component.
1. Unscrew the two junction box cover screws, and
unsnap and remove the junction box cover.
2. Route the 6-pin unit electrical cord from the AC to the
junction box location.
3. Plug the 6-pin unit electrical cord from the AC into
the matching 6-pin cable connector in the junction
box. The plug is keyed and will only fit in one
direction.
4. To avoid damage, run the 6-pin unit electrical cord
through the notch on the side of the junction box.
5. Route the 115 VAC power supply wire from the roof
opening to the junction box location.
6. Thread the 115 VAC power supply wire through the
strain relief.
7. Secure the 115 VAC power supply wire by tightening
the two screws on the strain relief. Make sure not to
damage the 115 VAC power supply wire.
7.4 Connecting the Power Supply
w
e
r
t
y
q
27 Junction Box
q
Junction Box Cover
Screws
r
Live Black Wire
w
Junction Box Cover
t
Copper Wire
e
Neutral White Wire
y
Green/Yellow
Ground Cord
This section describes how to connect the 115 VAC
power supply wire from the rooop component and the
6-pin unit electrical cord from the AC.
1. Connect the white neutral wires together, using
appropriately-sized connectors.
2. Connect the black live wires to each other, using
appropriately-sized connectors.
3. Connect the bare copper wire to the green/yellow
ground cord, using appropriately-sized connectors.
To Next Page
Loading...
Need help?
General
