39
EN
CapTouch Cabin Control Disposal
Problem Possible Causes Recommended Solution
A low pump-flow
fault is present, if
applicable.
The condenser coil is too hot.
Verify the unit receives water flow and the condenser is not fouled.
The thermistor is damaged.
• Unplug the water sensor if installed.
• Install another thermistor if one is available.
There is a damaged jack/socket on the circuit
board.
Visually check to verify the pins inside the socket are not bent or corroded.
Repair or replace the circuit board if needed.
A filter reminder is
presented.
The timer setting to clean or replace the filter
has been reached.
Clean or replace the filter and reset the filter hours.
9 Disposal
M
Place the packaging material in the appropriate
recycling waste bins, whenever possible. Consult
a local recycling center or specialist dealer for
details about how to dispose of the product in
accordance with all applicable national and local
regulations.
10 Warranty Information
LIMITED WARRANTY AVAILABLE AT WWW.DOMETIC.
COM/WARRANTY.
IF YOU HAVE QUESTIONS, OR TO OBTAIN A COPY
OF THE LIMITED WARRANTY FREE OF CHARGE,
CONTACT:
DOMETIC CORPORATION
MARINE CUSTOMER SUPPORT CENTER
2000 NORTH ANDREWS AVENUE
POMPANO BEACH, FLORIDA, USA 33069
1-800-542-2477
To Next Page
Loading...
Need help?
General
