Using the toilet CT4110, CTS4110
22
6.2 Preparing the cassette tank
Removing the cassette tank
Proceed as follows (fig. 3, page 4):
➤ Open the service door.
➤ Push the catch upward to unlock the cassette tank.
➤ Pull the cassette tank out of the cassette housing. When pulling out the tank,
resistance has to be overcome.
Adding sanitary additive
➤ Position the cassette tank upright.
➤ Rotate the drain pipe approx. 90° upward (fig. 4, page 4).
I
➤ Twist off the cap (fig. 5, page 5).
➤ Add sanitary additive into the cassette tank via the drain pipe (fig. 6, page 5).
Observe the instructions for the sanitary additive.
Pushing the cassette tank into the cassette housing
A
➤ Slide the cassette tank all the way into the cassette housing.
✓ The cassette tank lock locks by itself upon being pushed in.
➤ Check that the cassette tank is securely installed.
➤ Close and lock the service door.
NOTE
Avoid turning the drain pipe more than 90°, as it otherwise can come off
(fig. 4, page 4).
NOTICE!
Ensure that the cassette tank can be pushed into the cassette housing
easily. Make sure that the cassette tank does not bump into other
objects or components.
CT4000--O--USA.book Seite 22 Dienstag, 6. März 2018 1:39 13
To Next Page
Loading...
Need help?
General
