CT4110, CTS4110 Using the toilet
23
6.3 Using the toilet
The toilet lid remains in a position of approximately 70° (fig. 7 1, page 6).
I
➤ Before use, press the flush button to allow some water to run into the bowl
(fig. 7 2, page 6).
➤ Pull the slider (fig. 7 3, page 6) forward. Leave the slider open during use.
➤ After use, press the flush button again to rinse the bowl (fig. 8 1, page 6).
➤ Close the slider (fig. 8 2, page 6).
The cassette tank has a capacity of 19 l. When the indicator lights up, the toilet
can only be used a few more times.
I
6.4 Draining the cassette tank
Empty the cassette tank when the indicator lights up.
➤ Remove the cassette tank (chapter “Removing the cassette tank” on page 22).
➤ Press the release button in the middle of the handle and pull the handle out to its
end position (fig. 9, page 7).
A
➤ Bring the tank to the nearest designated disposal location.
➤ Press the release button in the middle of the handle and push the handle back
into the cassette.
NOTE
The slider must be closed while driving, and no liquid should be above
the slider.
NOTE
With a 3/4-filled cassette, use is only possible when the slider is open.
With a tilted position (such as lasting inclination of the vehicle), the
cassette may only be 3/4 full. Overflowing through the vent is possible.
NOTICE!
• Do not shake the cassette tank vigorously.
• Do not hang the cassette tank on a bicycle or other vehicle for trans-
portation.
• Do not place heavy objects on the cassette tank during transport.
This can damage the housing and rollers.
CT4000--O--USA.book Seite 23 Dienstag, 6. März 2018 1:39 13
To Next Page
Loading...
Need help?
General
