Dräger Vamos User Manual

Operation in Measurement Mode
33
Operating Instructions Vamos, 1. US ed.
Enabling Anesthetic Agent Measurement (Release Mode)
Enabling Anesthetic Agent Measurement
(Release Mode)
The Release Mode can be used to enter the release code to
enable the anesthetic agent measurement option. If the Vamos
is not equipped with this option initially, it can be updated
separately.
To enter Release Mode:
● Adjust in the following sequence:
● Switch Vamos to Standby Mode with the » « key,
● Keep pressed the »g« key,
● Keep pressed the » « key,
● Release »g« key,
● Release » « key.
The following information is shown:
● fabrication number of the device
● device identification number
This information has to be given for ordering the anesthetic
agent measurement option.
After ordering a device specific 10 digit Release code will be
sent by Dräger:
● Please, write down the Release code here:
To enter the Release Code:
● Turn dial knob to set first digit of Release code
● Press dial knob to confirm setting
● Repeat this procedure for all digits of the Release code.
After the last digit has been entered Vamos verifies the
entered code. If the correct code has been entered the
following message is shown:
Agent option released
● Switch Vamos off and on to enable the option.
If a wrong code has been entered, the following message
is shown:
Wrong Code
● Press »g« key, enter Release Mode again and repeat the
procedure.
Release Mode
Fab.No. :
0
AAAA-0000
12345678
000000000
Device ID :
Enter Release Code
RETURN TO THIS MANUAL'S TABLE OF CONTENTS
RETURN TO CD-ROM TABLE OF CONTENTS

Dräger Vamos Specifications

General

Brand	Dräger
Model	Vamos
Category	Monitor
Language	English