2
General Safety Warnings.........................................................................3
Symbols...................................................................................................5
FCC Compliance .....................................................................................6
Information on Intellectual Property.........................................................6
Specifications ..........................................................................................7
3D20 Resources......................................................................................8
Glossary of Terms....................................................................................8
Getting To Know Your Dremel 3D20......................................................10
Introduction............................................................................................12
Kit Contents and Unpacking ..................................................................12
Touch Screen.........................................................................................14
Software Install and Registration...........................................................21
Dremel Software Overview....................................................................22
Installing Filament and Getting Ready to Build......................................25
Building..................................................................................................28
Building From The SD Card ..................................................................29
Building From Your Computer ...............................................................30
Removing Your Object...........................................................................31
Troubleshooting .....................................................................................32
Maintenance and Service ......................................................................33
Best Practices........................................................................................34
Open Source Software ..........................................................................35
Dremel
®
Consumer Limited Warranty ....................................................36
Table of Contents
Safety Symbols
The definitions below describe the level of severity for each signal word. Please read the
manual and pay attention to these symbols.
This is the safety alert symbol. It is used to alert you to potential
personal injury hazards. Obey all safety messages that follow this
symbol to avoid possible injury or death.
DANGER indicates a hazardous situation which, if not avoided, will
result in death or serious injury.
WARNING indicates a hazardous situation which, if not avoided, could
result in death or serious injury.
CAUTION, used with the safety alert symbol, indicates a hazardous
situation which, if not avoided, will result in minor or moderate injury.
To Next Page
Loading...
Need help?
General
