Dremel Idea Builder 3D20-01 User Manual

7
Functional Description and Specifications
BUILDING
Extruder: Single extrusion
Extruder temperature: Up to 230°C (397°F)
Operating Interface: 3.5” full color IPS touch
screen
Maximum Build Volume: 9” x 5.9” x 5.5”
(230mm x 150mm x 140mm)
Layer Thickness: 4 mil | 0.004 inches 100
microns | 0.10 mm
Filament Colors: See
www.digilab.dremel.com for color choices
SD Card: Up to 32GB in size (3D20 will not
work with SD cards larger than 32GB)
Internal Storage: 4GB
WEIGHT & DIMENSIONS
Weight (without spool): 8.8kg (19lbs 8oz)
Dimensions: 19.1” x 15.7” x 13.2” (485mm x
400mm x 335mm)
FILAMENT
ONLY works with Dremel PLA filament
Filament: 1.75mm PLA
(Biodegradable/Renewable)
FILAMENT STORAGE
All polymers degrade with time. Do not
unpack until filament is needed. Filament
should be stored at room temperature: 16-
29° C (60-85° F)
SOFTWARE
Dremel 3D20 comes with complimentary
Dremel 3D software for Windows and Mac
OSX. This application converts your 3D
digital files into buildable files.
MINIMUM HARDWARE REQUIREMENTS
A PC with these minimum requirements will
be required to run the Dremel® 3D Software
Processor: Multi-core processor - 2 GHz or
faster per core
System RAM: 2 GB
Screen Resolution: 1024x768
USB port
WINDOWS REQUIREMENTS
Dremel® Software runs on 32 and 64-bit
Operating Systems
Windows Vista or later
MAC OSX REQUIREMENTS
Dremel® Software runs on Mac OSX 10.8 or
later
ELECTRICAL REQUIREMENTS
3D20 input rating: 120V, 60Hz, 1.2A
OPERATING ENVIRONMENT
Room Temperature: 16-29° C (60 - 85° F)
Level workspace
Dry workspace environment
15.7” (400mm)
19.1” (485mm) 13.2” (335mm)
WALL
8” (203mm)
8” (203mm)8” (203mm)
14” (356mm)
2610035691 03-18 3D20_3D20 3/8/18 10:35 AM Page 7

Dremel Idea Builder 3D20-01 Specifications

General

Brand	Dremel
Model	Idea Builder 3D20-01
Category	3D Printers
Language	English