28
Building
NOTE: Your Dremel 3D20 will build test
objects before leaving the factory. These test
objects may have been made with a different
filament color than you are using. Therefore,
a small amount of filament may be remaining
in the extruder. The start of your first object
may have some of this filament color until it
transitions over to your filament color.
You have 2 options when building on your
Dremel 3D20:
1. On-Printer Storage - On the main screen,
tap the “Build” option. Then tap the
machine icon to select from pre-installed
models.
2. Computer – Build directly from your
computer through the USB cable.
Observe all provided warnings and safety instructions when using the
Dremel 3D20. Failure to do so may result in fire, equipment damage,
property damage or personal injury.
!
WARNING
To Next Page
Loading...
Need help?
General
