12
Two-Way Wireless Key (WT4989, WT8989)
The Two-way Wireless Key communicates directly with the control panel, performing many of the
functions that a wireless keypad performs. Please refer to the WT4989/8989 Operating instruc-
tions for more information.
The WT4989 and WT8989 has 4 function keys programmable for 6 functions each, an LCD icon
display that can display system status using a combination of 7 icons and an internal buzzer.
Unless custom programmed by your installer the functions are as follows:
Function Keys
WT4989/WT8989 Status Display Icons
The table below summarizes the status that can be shown by the WT4989/WT8989 LCD:
Buzzer
Provides an audible confirmation of a pressed button or that a command to the panel has been executed.
Keylock Mode
Ensures that the system is not accidently armed or disarmed by the wireless key.
To lock the keys:
1. Press and hold the Status and Away keys simultaneously for 3 seconds.
2. After 3 seconds, the wireless key will beep and flash the keylock icon (
) to indicate that the
keys are locked.
To unlock the keys:
1. Press and hold the Status and Away keys simultaneously for 3 seconds.
NOTE: Pressing the Panic
key for 3 seconds will also exit Keylock mode.
2. Upon exiting Keylock mode, the status will be automatically displayed.
Testing Your System
NOTE: Inform your Monitoring Station when you begin and end system testing.
All smoke detectors in this installation must be tested by your smoke detector installer or dealer
once a year to ensure they are functioning correctly. It is the user’s responsibility to test the sys-
tem weekly (excluding smoke detectors). Ensure you follow all the steps in the two tests below.
NOTE: Should the system fail to function properly, call your installer immediately for service .
Status Request - Press this button for 1 second to view the control panel system
status via the LCD display icons.
Stay Arming - Press to arm your system in Stay mode. All perimeter zones are active
but interior zones remain inactive.
Away Arming - Press to arm your system. Interior and exterior zones will be armed.
Disarm - Press to disarm your system.
Panic Alarm -
Press & hold for 3 seconds to create a panic alarm on the security system.
*
Command Output 1 -
Press & hold both buttons at the same time for 3 seconds to
activate the assigned output.
*Command Output 2 - Press & hold both buttons at the same time for 3 seconds to
activate the assigned output.
ICON (S=Steady, F=Flashing)
(S) System Trouble (S) Alarm in Memory
(F) Keylock Enable (F) Active Alarm
(S) Disarmed (F) [][9] Armed - Away
(S) Away - Armed (F) [][9] Armed - Stay
(S) Stay - Armed (F) [][9] Armed - Night
(S) Night - Armed (S) Low Battery
(F) Critical Low Battery
To Next Page
Loading...
Need help?
General
