SAFETY INSTRUCTIONS FOR SERVICE PERSONNEL
WARNING: WHEN USING EQUIPMENT CONNECTED TO THE TELEPHONE NETWORK, THERE ARE
BASIC SAFETY INSTRUCTIONS THAT SHOULD ALWAYS BE FOLLOWED. REFER TO THE SAFETY
INSTRUCTIONS PROVIDED WITH THIS PRODUCT; SAVE THEM FOR FUTURE REFERENCE.
INSTRUCT THE END-USER REGARDING THE SAFETY PRECAUTIONS THAT SHALL BE OBSERVED
WHEN OPERATING THIS EQUIPMENT.
Before Installing The Equipment
Do not use a sharp or metal object to open the packaging! Ensure your package includes the following items:
• User’s Guide (Manual) including the Safety Instructions. Read and save these Instructions.
Follow all Warnings and Instructions specified within these Instruction and/or on the equipment.
• Equipment SCW904x
• Power Supply, Direct Plug-In
• Mounting Hardware
Selecting A Suitable Location For The Alarm Controller
Use the following list as a guide to find a suitable place for this equipment:
• Locate it near a telephone socket and a power outlet
• Select a place that is free from vibration and shocks
• Place the Alarm Controller on a flat, stable surface and follow the Installation suggestions
Do NOT locate this product where persons will walk on the secondary circuit cable(s).
Do NOT use extension cords to PLUG-IN the Power Supply of this equipment.
AV O ID setting up the equipment near heaters, air conditioners, ventilators, and/or refrigerators.
Do NOT connect the Alarm Controller to electrical outlets on the same circuit as large appliances.
Do NOT select a place that exposes your alarm controller to direct sunlight, excessive heat, moisture, vapors, chemicals or dust.
Do NOT install this Equipment near water. (e.g., Bath Tub, Wash Bowl, Kitchen/Laundry sink, In a wet basement, or near swimming pool, etc.).
Do NOT install this equipment and its accessories in areas where there is a risk of explosion.
Do NOT connect this Alarm Controller to electrical outlets controlled by wall switches or automatic timers; avoid interference sources.
Safety Precautions Required During Installation:
• NEVER install this equipment and/or telephone wiring during a lightning storm
• NEVER touch uninsulated telephone wires or terminals unless the telephone line has been disconnected at the network interface
• Ensure that cables are positioned so that accidents can not occur. Connected cables must not be subject to excessive mechanical strain
• Use only the power supply supplied with this equipment. Use of unauthorized power supplies may cause damage
• The AC socket/outlet powering the equipment shall be located near the equipment and shall be easily accessible
WARNING
THIS EQUIPMENT HAS NO MAINS ON/OFF SWITCH. THE PLUG OF THE DIRECT PLUG-IN POWER
SUPPLY IS INTENDED TO SERVE AS THE DISCONNECTING DEVICE IF THE EQUIPMENT MUST BE
QUICKLY DISCONNECTED. IT IS IMPERATIVE THAT ACCESS TO THE MAINS PLUG AND ASSOCI-
ATED MAINS SOCKET/OUTLET, IS NEVER OBSTRUCTED.
To Next Page
Loading...
Need help?
General
