17
E
Procedure to disable immobilizer engine
block through throttle twistgrip
1) Turn the key to ON and fully open throttle. Keep it open.
The EOBD warning light (7, fig. 4.1) turns off after 8
seconds.
2) Release the throttle as soon as the EOBD warning light
turns off.
3) It is now necessary to enter the electronic code
indicated on the CODE CARD delivered to the customer
together with the bike. EOBD pilot light will flash.
Count as many flashes of the EOBD pilot light (7, fig.
4.1) as the first digit of the electronic code.
Open the throttle fully. In this way the input of one
figure is acknowledged, EOBD pilot light comes on and
stays on for 4 seconds.
Failure to comply with this procedure, the EOBD pilot
light will flash for 20 times, then will come on steady.
Repeat the procedure starting from step (1).
4) Release the throttle as soon as the EOBD warning light
turns off.
5) Carry out steps 3 and 4 for the following figures of the
code until entering the last figure.
6) Release the throttle twistgrip, if the code is correct, the
EOBD warning light shall flash signalling that engine
block has been disabled. The warning light turns off
after 4 seconds. If the code is NOT correct, the EOBD
warning light stays on and it is then possible to turn the
key to OFF and repeat the procedure, starting from point
(1), as many times as necessary (infinite).
Note
Should the throttle twistgrip be released before the set
time, the warning light turns on again. It is then necessary to
bring the key to OFF and restart the procedure from point (1).
To Next Page
Loading...
Need help?
General
