Duplo DB-200 User Manual

~25~
3.3 Selection of Installation Location
1. Install the machine on a level safe, firm and solid table which will hold the weight of the machine.
2. Keep the machine away from the direct sunlight and heat sources such as stoves, heaters and radiators.
3.4 Installation/Drawing
Note: You must remove the three red shipping brackets before installing your DB-280
The procedures for installation:
Remove the red shipping bracket located on the
left side of the clamp station as shown. Then
reinstall the screws in clamp station.
Remove two red shipping brackets that are
located around the nipping station as shown.
Please remove the M6 screw which located
around the Glue Tank
Lift up your DB-280, slide in the bottom cover
first. Then slide in the glue draining tray
underneath the glue tank as shown.
Place your DB-280 on a safe, firm and solid
table. Then mount the cover-sheet holder to the
right side of the machine as shown.

Duplo DB-200 Specifications

General

Brand	Duplo
Model	DB-200
Category	Binding Machine
Language	English