~60~
5.4 Test Of Safety Devices
•
TEST1
–
Operation
Test:
Press and hold down the “FUNCTION” and “START” buttons, then turn the power on. You should see the
“TEST1” in the LED display. After performing the “WARM”, “HOT”, and “S-TEST” processes, the DB-280
will execute the entire operation test procedures as the following order:
Open the clamps
￠
Close the clamps
￠
Move clamp station to pass the notching station / Run the notching wheel
￠
Back to nipping station
￠
Up/Down the nipping station / Close/Open the nipping plates
Note: Test1 is an infinite loop. To return to MANUAL operation, you can stop Test1 by pressing the
FUNCTION button when the LED display shows "READY".
•
TEST2
–
Module
Test:
Press and hold down the “FUNCTION” and “STANDBY” buttons, then turn the power on. You should see
the “TEST2” in the LED display. After performing the “WARM”, “HOT”, and “S-TEST” processes, the
DB-280 will display “MOTOR 1” in the LED display. Then you can select the following module tests by
pressing “OPEN” or “CLOSE” button to toggle “MOTOR 1”, “MOTOR 2”, “MOTOR 4”, and “MOTOR 6”
followed by pressing “START” button to execute.
MOTOR 1 (Main motor motion):
Moves clamp station to notching station, then back to nipping station.
MOTOR 2 (Nipping motor motion):
Moves the nipping station surface to the highest point, the sub-high point, and the lowest
point and provides the nipping force for nipping plates.
MOTOR 4 (Notching motor motion):
Runs the notching wheel for a few seconds.
MOTOR 6 (Clamp motor motion)
Opens the clamps, then close the clamps.
Note: To return to MANUAL operation, press FUNCTION button when LED display shows
"MOTOR1/2/4/6".
•
Displays
the
total
amount
of
bookbinding:
Press and hold down the “FUNCTION” and “CLEAR” buttons, then turn the power on. You should see the total
amount of bookbinding in the LED display.
To Next Page
Loading...
Need help?
General
