46
(3) Checking the Motions – TEST2
Please refer to the “Checking the motions” section of the electricity on page 27 for
details.
(4) Making Sample Books
Run the following modes and make some sample books to see if every mode is
functioning properly and doesn’t form the nail head or round angle on the spine of
books.
Pad:
Set the glue meter to minimum position and the operating mode to “PAD” with
“NOTCH”. Then make a 40mm (1.57”) book to see if the glue thickness and notching
depth are evenly distributed on the spine. Note that the standard glue thickness is 0.4 to
0.5 mm or (0.015” to 0.020”) while the standard notching depth is 0.7mm or (0.028”.)
Manual:
Set the operating mode to “MANUAL”. Then make three 6.35 mm (¼”), 12.7 mm (½”),
25.4 mm (1”), and 40mm (1.57”) books in MANUAL mode.
Auto:
Set the operating mode to “AUTO”. Then make five 6.35 mm (¼”), 12.7 mm (½”), 25.4
mm (1”), and 40mm (1.57”) books in AUTO mode.
3. Maintenance Parts List
PARTS
NO.
DESCRIPTION SECTION QTY
E1004 Lifting Cam for Nipping Station (4) Nipping Station 1
E1008 Bearing Shaft for Lifting Bracket (4) Nipping Station 1
E1011 Hinge Seat for Nipping Station (4) Nipping Station 2
E1012 Hinge Shaft for Nipping Station (4) Nipping Station 2
E1017 Nipping Station Swing Arm (4) Nipping Station 4
E1026 Bearing Shaft for Nipping Slide Block (4) Nipping Station 4
E2005 Glue Wheel Bearing Shaft (3) Glue Tank 1
E3003 Notching Wheel (2) Notching Station 1
E3004 Notching Roller (2) Notching Station 4
E3005 Notching Position Spacer (2) Notching Station 2
E4002 Driving Shaft Slide Seat (6) Driving 2
E4004 Sprocket Shaft 1 (6) Driving 1
E4006 Chain Adjustment (6) Driving 1
E5003 Clamp Wheel Seat (5) Clamp Station 2
E5008 Clamp Worm Support (5) Clamp Station 1
E5009 Clamp Left-Right Worm (5) Clamp Station 1
E5010 Clamp Worm Seat (5) Clamp Station 2
E6018 Control Panel Hanger (1) Frame / Exterior Section 2
E6516A Clamp Beam Block Plate (5) Clamp Station 1
E6516B Clamp Beam Block Plate (5) Clamp Station 1
E6517 Block Plate for Clamp Wire Hose (5) Clamp Station 1
E7101 Main Motor ( M1 ) (6) Driving 1
To Next Page
Loading...
Need help?
General
