17
4. BINDING
4-3. Turning on Power of the Unit
After turning on the power of the upstream processing device (collator, etc.), turn on the power
of the unit and start binding operations using the upstream processing device. (Refer to “6-1.
Connecting the DC-10” for details of connecting the DC-10.)
Insert the power supply plug into the wall outlet, and set the power switch to ON.
Wait until the control panel display
stabilizes. If the unit has been used
before, the paper size used the last time
will be displayed.
When all the side-stapling and saddle-
stapling paper size lamps are blinking,
select the desired paper size.
These lamps will all blink in this way
when the power is turned off before the
size was memorized.
• When the desired paper size is selected, the joggers,
stoppers, and unit will start moving to the set
position.
1
When the power is turned on, the
automatic mode will be set.
• If performing the same operations as before the
power was turned on, binding operations can be
started after checking one set of testing binding.
2
NOTE : After this, the state of the monitor lamps will be as follows.
...... Blinking
...... Lit
...... OFF
A4
M5
A3
M3
A4
M4
M1
M2
To Next Page
Loading...
Need help?
General
