Error Message and Trouble Shooting
Error Message/Symptom Trouble Shooting
Paper Out 1. Feed Tray is empty
2. Check S1 refer to page 8 and 9
3. Is feed motor belt broken? If not,
4. Check pulley screw loose, if not
5. Refer to page 12 to do motor driver trouble shooting
Jam in Sensor 2 1. Check S2 refer to page 8 and 9
2. Adjust the feed tray tension
3. Refer to page 12 to do motor driver trouble shooting
Jam in Sensor 3 1. Check S3 refer to page 8 and 9, if it is OK
2. Replace driver board
Mark Error 1. Check S3 mark/margin sensor refer to page 8 and 9
2. Replace S3 if seeing paper LED is not ON
3. Do mark, top margin calibration
Die Sensor Error 1. Refer to page 8 and 9 and rotate die motor allow index is
seen by S4
2. LED Din 4 needs to be on, if not
3. Replace S4 die index sensor
Top Cover Error 1. Refer to page 8, make sure Din Check top cover interlock
switch
Rear Cover Error Check rear cover interlock switch
Waste Bin Error Check waste bin interlock switch
Finish card not clean and neat 1. Adjust the cutting knife guiding plate, if problem still
2. Replace cutting knife
Finish card length uneven 1. Adjust the cutter Assy. frame mounting screw on the side
plates
2. Check driving belt tension
3. Tighten the compression spring
Cutter Error 1. Driving crane screw loose, if not
2. Check S6, if it is OK
3. Refer to page 12 to do motor driver trouble shooting
Top margin not even left and right 1. Adjust the side guide, make sure it is right angle to the first
set of rollers
Transport no function 1. Check motor pulley screw is loose, If not
2. Check pulley on driving shaft/roller is loose, if not
3. Refer to page 12 to do motor driver trouble shooting
To Next Page
Loading...
Need help?
General
