6
CAUTION: DO NOT OPERATE heater without support frame assembled to tank.
NOTE:
4. FUELS
For optimal performance of this heater, it is strongly suggested that 1-K kerosene be used. 1-K kerosene has
sulfur. Which can cause a rotten egg odor during
the operation of the heater. However, #1/#2 diesel/fuel oil, JET A or JP-8 fuels may also be used if 1-K
kerosene is not available. Be advised that these fuels do not burn as clean as 1-K kerosene, and care should
be taken to provide more fresh air ventilation to accommodate any added contaminants that may be added to
the heated space. #2 diesel/fuel oil heavier than 1-K kerosene in extreme cold temperatures
without nontoxic anti-icer additives will not ignite properly.
NEVER store kerosene in the living space. Kerosene should be stored in a well ventilated place outside the
living area.
NEVER use any fuel other than 1-K kerosene (#1/#2 diesel/fuel oil, JET A or JP-8 fuels are acceptable substitutes)
NEVER use fuel such as gasoline, benzene, alcohol, white gas, camp stove fuel, paint thinners, or other oil
compounds in this heater. These are volatile fuels that can cause an explosion or uncontrolled
NEVER store kerosene in direct sunlight or near a source of heat.
NEVER use kerosene that has been stored from one season to the next. Kerosene deteriorates over time.
KEROSENE SHOULD ONLY BE STORED IN A BLUE CONTAINER THAT IS CLEARLY
MARKED “KEROSENE”. NEVER STORE KEROSENE IN A RED CONTAINER.
Red containers are associated with gasoline.
“OLD KEROSENE” WILL NOT BURN PROPERLY IN THIS HEATER.
NEVER LEAVE THE HEATER
UNATTENDED WHILE BURNING!
Figure 7. Assembling Handle, Wheel and Cord wrap
Hot Air Outlet
Fuel Tank Flange
Nut
Wheel Support Frame
Wheel
Cap Nut L
Cap Nut S
Rear Handle
Cord Wrap
Flange Screw
Threaded Axle
Wheel Bushing
Air Inlet
Front Handle
Screw
To Next Page
Loading...
Need help?
General
