Instruction Book
Effective: November 2017 Page 14
For more information visit: www.Eaton.com IB131016EN
WARNING
3-3 STORAGE
If the circuit breaker is to be placed in storage,
maximum protection can be obtained by keeping it
packed as shipped. Before placing it in storage,
checks should be made to make sure that the breaker
is free from shipping damage and is in satisfactory
operating condition.
Outdoor storage is NOT recommended. If
unavoidable, the outdoor location must be well
drained and a temporary shelter from sun, rain, snow,
corrosive fumes, dust, dirt, falling objects, excessive
moisture, etc. must be provided. Containers should be
arranged to permit free circulation of air on all sides
and temporary heaters should be used to minimize
condensation. Moisture can cause rusting of metal
parts and deterioration of high voltage insulation. A
heat level of approximately 400 watts for each 100
cubic feet of volume is recommended with the heaters
distributed uniformly throughout the structure near the
floor.
Indoor storage should be in a building with sufficient
heat and circulation to prevent condensation. If the
building is not heated, the same general rule for heat as
for outdoor storage should be applied.
THE CUSTOMER SHOULD READ AND
UNDERSTAND THE MATERIAL PRESENTED AND
ANY WARNINGS OR CAUTIONS OFFERED IN
THE INSTRUCTION BOOK BEFORE ANY
ATTEMPT IS MADE TO INTERFACE WITH THIS
CIRCUIT BREAKER.
IT IS IMPERATIVE THAT ALL APPLICABLE ANSI
STANDARDS BE COMPLIED WITH IN EVERY
RESPECT AND THAT NO COMPROMISES ARE
MADE WITH RESPECT TO THE ANSI
GUIDELINES OR INTENT.
UNDER NO CIRCUMSTANCES SHOULD
ALTERATIONS BE MADE TO EATON SUPPLIED
VCP-T OR VCP-TR CIRCUIT BREAKERS UNLESS
THE ALTERATION IS SPECIFICALLY ADDRESSED
IN AND PERMITTED BY THIS INSTRUCTION
BOOK.
Figure 3-4 Preferred Lifting Method Using Lifting Yoke
To Lift 25kA Breaker
Figure 3-4a Preferred Lifting Method Using Lifting
Yoke To Lift 40kA Breaker
To Next Page
Loading...
Need help?
General
