3 Introduction to Eaton UPS
33..11 AAbboouutt tthhee EEaattoonn UUPPSS
Figure 1. Eaton 93PM G2 UPS
The Eaton® 93PM G2 uninterruptible power supply (UPS) is a true online, continuous-duty,
transformerless, double-conversion, solid-state, three-phase system that supplies conditioned and
uninterruptible AC power to critical load and protects it from power failures.
The UPS is used to prevent loss of valuable electronic information, minimize equipment downtime, and
minimize the adverse effect on production equipment due to unexpected power problems.
The Eaton UPS continually monitors incoming electrical power and removes the surges, spikes, sags, and
other irregularities that are inherent in commercial utility power. Working with a building’s electrical
system, the UPS system supplies clean, consistent power that sensitive electronic equipment require for
reliable operation. During brownouts, blackouts, and other power interruptions, batteries provide
emergency power to safeguard operation.
The UPS is housed in a single, free-standing cabinet with safety shields behind the door for protection
against hazardous voltage. Each UPS cabinet has a centralized system static bypass.
Eaton 93PM G2 output power ratings are based on 50 kVA and 60 kVA rated uninterruptible power
modules (UPMs) installed in 200/240 kVA or 300/360 kVA UPS frames. A single UPS cabinet can house
from one to four or six UPMs.
See Section
3.9 Basic system configurations for a full list of available configurations.
EATON 93PM G2 UPS USER’S AND INSTALLATION GUIDE P-164000956
-
February 2021 www.eaton.eu 1166
To Next Page
Loading...
Need help?
General
