Eaton 93PM G2 User Manual

7 UPS operating instructions
77..11 AAbboouutt UUPPSS ooppeerraattiinngg iinnssttrruuccttiioonnss
This section describes how to operate the UPS.
CAUTION
Before you operate the UPS, make sure that all the installation tasks are
completed and a preliminary startup has been performed by authorized service
personnel. The preliminary startup verifies all the electrical interconnections to
make sure that the installation was successful and the system operates
properly.
Before you operate any of the controls, read these instructions and have a
thorough understanding of the UPS operation.
The UPS is configured to operate with one of the following nominal voltages:
380, 400, or 415 VAC. Before you start to operate the UPS, confirm the UPS
nominal voltage and frequency from the display by selecting
Settings→Information. If the UPS need to be operated with another voltage or
frequency, contact your closest Eaton office or Eaton authorized partner.
NOTE: The UPS is not a measuring device. All the displayed measurements are approximate values only.
77..22 UUPPSS ccoonnttrroollss aanndd iinnddiiccaattoorrss
77..22..11 CCoonnttrrooll ppaanneell
The control panel contains a color touch screen display. It is used to display the status of the UPS system
and control the operation of the UPS.
Figure 39. Parts of the display
EATON 93PM G2 UPS USER’S AND INSTALLATION GUIDE P-164000956
-
February 2021 www.eaton.eu 6688

Eaton 93PM G2 Specifications

General

Brand	Eaton
Model	93PM G2
Category	UPS
Language	English