3 Installation and operation
Figure 1. 9PHD transformer cabinet TFC-A and external battery cabinets EBC-F and EBC-
G
3.1 Introduction to EBC-F and EBC-G
The Eaton external battery cabinets provide emergency short-term backup
power to safeguard operation during brownouts, blackouts, and other power
interruptions. The battery cabinets line-up and match with the Eaton UPS
product line, and should only be used in an Eaton UPS system. This manual
gives instructions on the use and installation of two battery cabinets: EBC-F and
EBC-G.
The EBC-F is designed to be used with an uninterruptible power supply (UPS)
that is rated up to 100 kW output power. The EBC-F has one battery string that
has 36 or 40 battery blocks.
The EBC-G is designed to be used with an uninterruptible power supply (UPS)
that is rated up to 200 kW output power. The EBC-G has one battery string that
has 36 or 40 battery blocks.
Control wiring for both EBC-F and EBC-G is supplied with the cabinet. The
battery cabinet can be located anywhere near the UPS cabinet, if you run the
Battery-to-UPS power wiring outside the cabinets. However, the recommended
way to install the cables is through the left side panel of the battery cabinet, with
the battery cabinet located next to the 9PHD UPS on its right side.
There are several cable entries in the battery cabinets. The cabinets can be
wired in the following ways.
Eaton 9PHD Accessory Cabinets TFC-A, EBC-F
and EBC-G User's and installation guide
©
Eaton Corporation plc 2022. All rights reserved. Document ID: P-164000538 14 (63)
To Next Page
Loading...
Need help?
General
