Eaton 9PHD User Manual

9. Slowly roll the cabinet toward
the ramp edge. Be careful not to
push the cabinet too much or
too fast since it may cause the
cabinet to tip over.
Note that the cabinet is heavy.
Make sure that you have
enough manpower to handle
and support the unit while rolling
it off the pallet.
10. Roll the cabinet to its final
installation location.
11. To secure the accessory
cabinet in position, lower the
leveling feet until the cabinet is
level.
Only use the leveling feet for
leveling. Do not lift the casters
off the ground, as the casters
should still carry most of the
cabinet’s weight.
12. You can reattach the shipping brackets to the accessory cabinet to
provide extra support. Position the shipping brackets on the front and
rear of the unit.
3.5.2 How to unpack and unload the EBC-G with casters
WARNING
The external battery cabinet is heavy. If you do not follow these instructions
closely, the cabinet may tip over and cause serious injury.
Do not tilt the cabinet more than 10 degrees from the vertical or the cabinet
may tip over.
Eaton 9PHD Accessory Cabinets TFC-A, EBC-F
and EBC-G User's and installation guide
©
Eaton Corporation plc 2022. All rights reserved. Document ID: P-164000538 25 (63)

Eaton 9PHD Specifications

General

Brand	Eaton
Model	9PHD
Category	Transformer
Language	English