42
Using BIOS
M.I.B. II (MB Intelligent BiosII)
This page enables you to set the clock speed and system bus for your system. The
clock speed and system bus are determined by the kind of processor you have installed
in your system.
CMOS Setup Utility - Copyright (C) 1985-2009, American Megatrends, Inc.
M.I.B.II (MB Intelligent BIOS II)
Help Item
Intel (R) Core (TM) 15 CPU 650@ 3.20GHz
Ratio Status: Unlocked (Min: 09, Max: 24)
Ratio Actual Value : 24
Intel CPU Clock : 733MHz
Current Memory Frequency : 1333MHz
Meomory Current Type :9-24-9-9-10-100-5-4-5-20
CPU Vcore : 1.128 V
VDIMM : 1.512 V
PCH Voltage: 1.032 V
Performance Level Standard
DRAM Frequency Auto
Configure DRAM Timing by SPD Auto
Memory Hole Disabled
DRAM Command Rate Auto
CPU Clock Select Auto
CPU Over-clocking Func: Disabled
PCIE Over-clocking Func: Disabled
Spread Spectrum Enabled
Auto Detect DIMM/PCI Clk Enabled
Voltage Function Disabled
Standard
Enhanced
Options
: Move F10: Save ESC: Exit
+/-/: Value
Enter : Select
F9: Optimized Defaults
F1:General Help
DRAM Frequency (Auto)
This item enables users to adjust the DRAM frequency. The default setting is auto and
we recommend users leave the setting unchanged. Modify it at will may cause the
system to be unstable.
Performance Level (Standard)
This item shows the performance level of the components, the options are: Standard
and Enhanced.
Configure DRAM Timing by SPD (Auto)
When this item is set to enable, the DDR timing is configured using SPD. SPD (Serial
Presence Detect) is located on the memory modules, BIOS reads information coded
in SPD during system boot up.
Memory Hole (Disabled)
This item allows users to enable or disable memory hole remapping.
DRAM Command Rate (Auto)
This item specifies the rate of the DRAM Command.
CPU Over-clocking Func (Disabled)
This item decides the CPU over-clocking function installed in your system. If the
over-clocking fails, please turn off the system power. And then, hold the PageUp key
(similar to the Clear CMOS function) and turn on the power, the BIOS will recover
the safe default.
CPU Clock Select (Auto)
This item allows users to select CPU clock.
To Next Page
Loading...
Need help?
General
Weight and Dimensions
