SD5/SD6 Ultrasonic TableTop Doppler User Manual Maintenance and Cleaning
- 27 -
Handle the probe with care to avoid damaging the cover, piezoelectric crystals and mechanical
movement. Do not contact the probe with hard or sharp objects.
Do not excessively flex the probe cable.
Wipe the remaining gel off the probe after use.
Keep the probes in a dry environment, where the temperature should be lower than 45°C.
6.3 Cleaning
To clean the main unit:
Switch off the Doppler and unplug it from AC power supply. Clean the case using a soft cloth
dampened with mild near neutral detergent, ethanol (75%) or isopropanol (70%), and then wipe it
dry with a dry cloth immediately. The recommended cycle is one week or when needed.
Clean the probe after each use to avoid cross infection and prolong its useful life.
To clean the probe:
Switch off the probe. Clean it using a soft cloth dampened with mild near neutral detergent,
ethanol (75%) or isopropanol (70%), and then wipe it dry with a dry cloth immediately.
CAUTION
1 Do not use strong solvent such as acetone.
2 Do not use an abrasive such as steel wool or metal polish.
3 Neither the main unit nor the probe is waterproof; do not immerse any part of them in
liquid. Entry of liquid into the Doppler may destroy the equipment.
4 Do not allow any liquid remain on the surface.
6.4 Disinfection
In normal use the main unit does not need disinfection. In case of being soiled, clean the main
unit case and then disinfect it by wiping it with a soft cloth dampened with ethanol (75%) or
isopropanol (70%). Then wipe it dry with a dry cloth.
After each use, clean the probe and then disinfect it by wiping it with a soft cloth dampened with
ethanol (75%) or isopropanol (70%). Then wipe it dry with a dry cloth.
To Next Page
Loading...
Need help?
General
