4
2. Connection
2.1. Bluetooth connection
Please complete the connection with your mobile before use. The steps are as below:
2.1.1. The distance between your mobile and the headphones should be kept within 1
m. The closer the better.
2.1.2. The headphones are powered on. Pressing multi-pad 3 seconds makes the
headphones into pairing status.
2.1.3. Enable your mobile’s Bluetooth and search Bluetooth devices. Select ‘EDIFIER
W830BT’ to pair up and connect. After being connected successfully, the prompt
beep sounds and the headphones’ blue light is flashing quickly.
Note:
1. In pairing status, the connection that cannot succeed in 3 minutes shall automatically
exit the pairing mode;
2. If your mobile prompts inputting the pairing password, please enter ‘0000’;
3. After completing pairing, the headphones and your mobile shall remember each
other. When used next time, the headphones shall automatically connect the device
that was connected last time.
2.2. NFC connection
If your Bluetooth mobile supports Near Field Communication (NFC), please enable
NFC of your mobile at first and switch on the headphones, then touch the NFC area
of W830BT with the NFC area of your mobile. W830BT shall pair up with your
mobile.
Note:
● When your mobile hibernates or is screen-locked, your mobile cannot be paired up by
using NFC.
● When pairing up at the first time, it is required that your mobile is in touch
with W830BT for a longer time and can only be taken away until
W830BT is in pairing mode.
● When no device is connected, connection can be done by using NFC; if
a device is already connected, the connection can be terminated by using NFC.
2.3. One operating 2 units connection
The headphones can be connected simultaneously with two Bluetooth devices. The
To Next Page
Loading...
Need help?
General
