INSTALLATION
25/64
EN
4.7 Oil systems
FUEL LEAKS
- Fuel leaks may cause re to break out.
- They may be toxic via inhalation and cause skin irritation.
- Act swiftly to remove the cause of the leak. If it is connected to a maintenance operation, use
the dedicated personal protective equipment.
WARNING
Danger of injury from gas in the atmosphere!
To prevent the formation of gas caused by worst combustion/deagration:
- when lling the tank, switch off the burner and leave it switched off for approximately 3 hours
to ensure degassing of the fuel and the deposit of suspended particles
- have any damage to the oil pipes repaired immediately by a specialised technician
- never operate the burner with the oil tank empty.
IMPORTANT INFORMATION
Corresponding legislation pertaining to water resources and the installation of fuel pipes must
be observed.
IMPORTANT INFORMATION
Leaks in the fuel supply system can cause combustion problems and malfunctions in the burner.
The fuel tank, including the installation of the pipes, must be carried out in such as way as to
ensure that the temperature of the oil going into the burner is at least + 5°C.
When the burner is replaced, also replace the fuel lter.
To Next Page
Loading...
Need help?
General