Settin Surface Controls
COOKWARERECOMMENDATIONS
m m m m m m m m [] [] [] [] [] [] [] [] [] [] [] [] [] []
iNCORRECT
o Cookware not centered on Cooking
Zone surface.
Curved or warped pan bottoms or
sides.
N====Min. size ====H
Pan does not meet the minimum
size required for the Cooking Zone
used.
Pan bottom rests on cooktop trim
or does not rest completely on the
cooktop surface.
Heavy handle tilts pan.
CORRECT
Cookware centered correctly on
Cooking Zone surface.
Flat pan bottom & straight sides.
N==Min. size ==d
Pan size meets or exceeds the
recommended minimum size for the
Cooking Zone.
W
Pan rests completely on the Cooktop
surface.
Pan is properly balanced.
Fig. 1
PLEASE NOTE - ANY one of the incorrect conditions listed above in Fig. 1 may be
detected by the sensors located below the ceramic cooktop surface. If the cookware
does not meet any of these conditions, one or more of the Cooking Zones will not heat
indicated by the turned off circle surrounding the digital display for that affected zone.
Correct the problems before attempting to reactivate the cooktop.
To Next Page
Loading...
Need help?
General
